The CNC Side Hustle (Expired) › Forums › CNC Tech Forum › Software › Reply To: Software

  • Miranda

    Administrator
    April 6, 2026 at 5:52 pm

    Here’s the basic workflow to follow:

    1. Download and unzip the files
    When you download the project, it’ll come as a zipped folder.
    Right-click → “Extract All” so you can access everything inside.

    2. Decide which route you’re taking

    • If you want to learn and tweak things → open the project file in your software
    • If you just want to run the job → use the G-code file

    3. If using the G-code (USG)

    • Open your control software (like UGS)
    • Connect to your machine
    • Load the correct G-code file (each file usually matches a specific bit or step)
    • Set your zero:
      • X/Y = lower left corner of your material
      • Z = top of material
    • Run the job

    4. Important:
    Most projects use multiple files (one per tool). That means:

    • Run first file (example: pocketing)
    • Change the bit when prompted
    • Re-zero Z only (not X/Y)
    • Run the next file

    A couple beginner tips that will save you headaches:

    • Always double-check your material size matches the project
    • Run an air pass first (lift the bit and simulate the cut)
    • Stay near the machine for your first few runs
    • Don’t rush; setup is everything in CNC